The Creality SparkX i7 Nano Combo is a compact, open-frame 3D printer that brings four-colour printing to the entry-level market without a separate filament box taking over the desk.
Read More
Wet filament is 3D printer filament that has soaked up moisture from the air. Inside the hotend that water boils into steam, which causes popping sounds, pitted walls, heavy stringing...
Read More
3D Printing Store stocks all five 3d printers for Cosplay covered here, with walk-in branches in Centurion and Boksburg.
Read More
PETG sticking to the nozzle comes down to four causes: molten PETG bonds readily to hot brass, wet filament spits plastic up the nozzle wall, a Z-offset set too low...
Read More
Spaghetti prints happen when a model breaks free from the build plate partway through a job, leaving the nozzle to extrude filament into empty air until a tangled nest of...
Read More
Ghosting and ringing on 3D prints show up as faint ripples, waves, or repeated shadow lines on the surface of a model, usually right after a sharp corner, a hole,...
Read More
In 2026, the Ender-3 V3 KE vs V4 debate is not really about “which one is faster”, it’s about whether linear rails actually remove the frustrating failure modes that steal...
Read More
A 3D print stopping mid-print almost always traces back to one of five causes: a corrupted SD card, heat creep inside the hotend, an overheating extruder motor driver, a tangled...
Read More
Z-banding on 3D prints shows up as repeating horizontal lines or ridges running up the sides of a model, and it almost always traces back to mechanical misalignment on the...
Read More
Elephant's foot happens when the bottom few layers of a 3D print bulge outward past the rest of the model, usually because the nozzle sits too close to the bed,...
Read More